 | Shop by category |
{"delay":300}
|
Have used this 3x now when installing optics on a handgun or just general working on an AR. Super easy to use and good quality. You can buy other ones that are much much more expensive, but this definitely gets the job done for the money. Would highly buy again! Good brand name, that carries a good warranty and quality product. The carrying case is decent for just being plastic. Would buy again
Verified purchase: Yes | Condition: New
Torque settings all over the place for any precision work. If you have WIDE torque specs it will work….Maybe I got the oddball, a lot of people use these…I’m just not a fan. I spent money on a good set and these can go on my rummage sale.
Verified purchase: Yes | Condition: New
I used this tool to install an AeroPrecision scope mount and a Monstrum 4-16x scope on my AR15 build. Very easy to use and comes with case and a nice assortment of bits (also accepts standard bits). Each wrench comes with a calibration card that shows exactly what the torque values are for each setting. Highly recommended.
Verified purchase: Yes | Condition: New
Really does make a difference when mounting a higher end scope. Really! The problem is over torquing which puts pressure on the optics in the tube which then results in sub standard focus. At first I mounted a Leupold 8.5-25X50mm L/R by "feel". My first thought peering through the scope was; "Hell! This isn't much better than the Vortex Crossfire ll that I just took off the rifle!" Did some research and decided to buy the in/lb torque wrench to properly mount the scope. It still was much cheaper than having a gunsmith mount the scope. The difference was night and day! I can now plainly and clearly see my .308 bullet strikes at 300 yards. Couldn't do that before! The torque specs for my scope with steel rings is 20 in/lbs. I had applied a great deal more than that with my sense of "FEEL" because I no idea what 20 in/lbs felt like. I can tell you now that 20 in/lbs is not very much AT ALL! Yup! It made this scope a long range beast.Read full review
Verified purchase: Yes | Condition: New
I love this Driver My 1/4" (Bar type) Torque Wrench is NOT good for what I needed it for The lowest setting is still way too high The FAT Wench is ideal for my needs and at a GREAT value The included Bits are an added bonus
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Smithing Equipment
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Smithing Equipment
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
